DSL Series - Combination Control

Application

Precise dual setpoint, digital combination control with heating and cooling.

Materials

N/A

Performance

Dual setpoint with heating and cooling up to 30 amps

Specifications

Please see product bulletin for details

Features

- Easy to read .3” (7.6mm) dual LED displays. Two set points (heating and cooling). Provides precise control for consistent plating and etch rates in most aqueous processes

- NEMA 1, IP21, flame retardant and gasketed plastic enclosure with stainless steel hardware

- 20°F(-7°C) to 140°F(60°C) ambient temperature range

- Single or three phase

- Fluoropolymer (FEP) covered 10-foot (3m), 1000-ohm platinum RTD sensor included standard with the control. Provides extended service in corrosive liquids and can be lengthened with ordinary copper wire

- Large switching capacities from 20 to 125 amps for up to 600 volts

- ±.25% full span, single digit accuracy

- Auto tune PID, PID or On/Off control with Auto/Manual operation (Solid state relay required - these features are non-UL)

Quote Request

Dual Set-Point, 20 - 125 amps

Provides precise digital control for consistent plating and etch rates in most aqueous processes. Combination control features .3 inch (7.6mm), dual LED displays. Fluoropolymer (FEP) covered 10-foot 3m), 1000-ohm platinum RTD sensor included standard with the control. NEMA 1, IP21, flame retardant and gasketed plastic enclosure with stainless steel hardware. Dual setpoint with heating and cooling up to 30 amps. 120-240 volts. Single phase. Adjustable temperature range from -328°F (-200°C) to 4208°F (2320°C).

Options: Scalable voltage and current inputs. 4-20 mA or 0-10VDC outputs for process recording. 4-20 mA or 15VDC control outputs. RS485 communication protocol. Three wire 100-ohm RTD sensors. Type J, K, T, & R thermocouples. Special sensors required for temperatures above 500°F(260°C). 25-foot (7.6m) and 50-foot (15.2m) sensors. P2, P3 or P8 theyyrmal protection systems. Integrated liquid level control components. Front panel mounted digital timers. Pre-wired outlets for plugin heaters (some sizes). Ground fault protection of equipment (GFPE) circuitry. NEMA 4/4X enclosure (with internal heater for outdoor use).

Safety: Pre-wired P1 terminal blocks. Non-volatile memory. Programmable high or low temperature alarm output. Sensor short and break protection Programmable high set point limit. Security code restricted menu.

Process Technology Product Bulletin

Download file

Category