DSL Series Relay/Control

Application

Precise dual setpoint digital control / power relay with heating and cooling.

Materials

N/A

Performance

Dual Set-Point, 30 amps.

Specifications

Please see product bulletin for details

Features

- Easy to read .3” (7.6mm) dual LED displays. Two set points (heating and cooling). Provides precise control for consistent plating and etch rates in most aqueous processes.

- NEMA 1, IP21, flame retardant and gasketed plastic enclosure with stainless steel hardware

- 20°F(-7°C) to 140°F(60°C) ambient temperature range

- Single or three phase

- Fluoropolymer (FEP) covered 10-foot (3m), 1000-ohm platinum RTD sensor included standard with the control. Provides extended service in corrosive liquids and can be lengthened with ordinary copper wire

- Large switching capacities from 20 to 125 amps for up to 600 volts

- ±.25% full span, single digit accuracy

- Auto tune PID, PID or On/Off control with Auto/ Manual operation (Solid state relay required -these features are non-UL)

Quote Request

Dual Set-Point, 30 amps.

Provides precise digital control and power relay for consistent plating and etch rates in most aqueous processes. .3 inch (7.6mm), dual LED displays. Fluoropolymer (FEP) covered 10-foot 3m), 1000-ohm platinum RTD sensor included standard with the control. NEMA 1, IP21, flame retardant and gasketed plastic enclosure with stainless steel hardware. Heating and cooling up to 30 amps. 240 -480 volts. Single phase. Adjustable temperature range from -328°F (-200°C) to 4208°F (2320°C).

Options: Scalable voltage and current inputs. 4-20 mA or 0-10VDC outputs for process recording. 4-20 mA or 15VDC control outputs. RS485 communication protocol. Three wire 100-ohm RTD sensors. Type J, K, T, & R thermocouples. Special sensors required for temperatures above 500°F(260°C). 25-foot (7.6m) and 50-foot (15.2m) sensors. P2, P3 or P8 thermal protection systems. Integrated liquid level control components. Front panel mounted digital timers. Pre-wired outlets for plugin heaters (some sizes). Ground fault protection of equipment (GFPE) circuitry. NEMA 4/4X enclosure (with internal heater for outdoor use.

Safety: Pre-wired P1 terminal blocks. Non-volatile memory. Programmable high or low temperature alarm output. Sensor short and break protection. Programmable high set point limit. Security code restricted menu.

Category